Repro steel wheels?
2 posters
Page 1 of 1
Repro steel wheels?
I am thinking of going from the 3.5 inch steel to the 4.5 repro Cooper steel wheel and keeping the standard hub caps. I have read that there were some cheap repros that wouldn't take the standard hub caps? Any experience out there ? I am not going to be fitting flared arches so anything wider is out.
Cheers, Tony
Cheers, Tony
flat broke- Posts : 18
Points : 4871
Join date : 2011-02-03
Caps
Ive only done this with Hornet caps and not Elf. However, I can confirm that they do not fit, without modification - the little raised sections dont come out far enough - I had to weld on to the wheels and then grind out a better groove to get standard trims to fit the repro wheels. Its a bit of a fiddle but works ok.
Oh! You will also need to widen the slot that the valve comes from as it will be crushed by the trim!
Oh! You will also need to widen the slot that the valve comes from as it will be crushed by the trim!
DyNoRod- Posts : 204
Points : 5859
Join date : 2008-11-19
Age : 50
Location : Oxfordshire
Similar topics
» 10" steel wheels
» Steel Wheel 10"
» stainless steel / enamel grille badges for EHR
» Wanted: 4.5x10 minilites
» matts elf project
» Steel Wheel 10"
» stainless steel / enamel grille badges for EHR
» Wanted: 4.5x10 minilites
» matts elf project
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|